|
CYCLE RATE:
|
Up to 70 bags
per minute (Dependent on fill time, seal dwell, and package length)
|
| BAG
WIDTH: |
1.5"
to 14" wide [3.8 cm - 35.6 cm] |
| BAG
LENGTH: |
With
Load Shelf- 5" to 15" long [13 cm - 38 cm]
No Load Shelf- 1" to 20" long [2.5 cm - 51 cm] |
| MATERIAL
THICKNESS: |
1
mil to 6 mil |
| MATERIAL
TYPES: |
Pre-Opened
Bags-On-A-Roll made of any material that can be sealed by heat, such
as but not limited to: high and low density polyethylene, polypropylene,
tyvek, vinyl, etc. |
| CONSTRUCTION: |
Precision
machined and anodized aluminum frame
Stainless steel and hard chrome plated hardware
Sealed ball bearings |
| CONTROLLER:
|
PLC |
| OPERATOR
INTERFACES: |
5.7"
Color Touch Screen
Digital PID Temperature Controller |
| OPERATING
MODES: |
Manual-
Each cycle initiated by human operator
Automatic- Continuous timed cycling
Auxiliary- Each cycle is initiated by an input signal from an interfaced
device. |
| I/O
INTERFACING: |
Inputs-
Begin Cycle [Closed Contact Needed]
Aux Equipment Ready [Closed Contact Needed]
Outputs- Ready To Fill [24 VDC signal out]
Bagger Ready [24 VDC signal out] |
| DRIVE
MOTOR: |
Stepper
Motor can advance bags up to 24" per second |
| BAG
REGISTRATION: |
Spark
perforation sensor |
POWER
REQUIREMENTS: |
110
volts AC +/- 5%, 50-60 Hz, 6 amps max. |
AIR
REQUIREMENTS: |
80-100
PSI, dry and filtered |
OPERATING
ENVIRONMENT: |
50-100°
F [10-38° C]
10% - 85% relative humidity (Non-condensing) |
| WEIGHTS: |
Bagger
Body- 45 lbs [20.5 kg]
Electronics Module- 32 lbs [14.5kg]
Hydraulic Lift Table- 85 lbs [38.6 kg] |
